LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Frontier SL, RWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Unit Disassembly And Assembly >> Steering Gear And Linkage >> Disassembly and Assembly >> Assembly

Disassembly and Assembly: Assembly

  1. Install the inner sockets.
  2. Install the large-diameter side of the boots to the gear housing assembly.
  3. Install the small-diameter side of the boots to the groove of the inner sockets.
    Fig 1: Identifying Boot & Clamps
    G04876909Courtesy of NISSAN NORTH AMERICA, INC.
  4. Install the boot clamps to the boots, as shown below.
    CAUTION: Do not reuse the large boot clamps.
    Fig 2: Identifying Clamps
    G04902323Courtesy of NISSAN NORTH AMERICA, INC.
  5. Crimp the large boot clamps, using Tool.

    Tool number: KV40107300 (-) 

    Fig 3: Crimping Boot Clamp
    G04902012Courtesy of NISSAN NORTH AMERICA, INC.
  6. Install the cylinder tubes to the gear housing assembly.
  7. Install the lock nuts and outer sockets to the inner sockets.
  8. Thread the outer sockets onto the inner sockets to the specified length (L) and a minimum thread depth of 18 threads, then tighten the lock nuts to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ". Reconfirm that the tie-rod length (L) is within specification.

    Maximum inner socket length (L) Refer to  "STEERING GEAR "

    Fig 4: Identifying Tie Rod Length
    G07019602Courtesy of NISSAN NORTH AMERICA, INC.