LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Frontier SL, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Control System (Qr25DE)) >> DTC/Circuit Diagnosis >> DTC P0453: EVAP Control System Pressure Sensor >> Component Inspection >> EVAP Control Pressure Sensor

EVAP Control Pressure Sensor

WARNING: This page is about a different car, the 2011 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove EVAP control system pressure sensor with its harness connector.

    Always replace O-ring with a new one. 

  2. Install a vacuum pump to EVAP control system pressure sensor.
  3. Turn ignition switch ON and check output voltage between ECM terminal 32 and ground under the following conditions.
    VOLTAGE REFERENCE

    Applied vacuum kPa (kg/cm2 , psi) Voltage (V)
    Not applied 1.8 - 4.8
    -26.7 (-200, -7.87) 2.1 to 2.5V lower than above value
    Fig 1: Checking EVAP Control System Pressure Sensor Voltage
    G07118660Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION:
    • Always calibrate the vacuum pump gauge when using it.
    • Never apply below -93.3 kPa (-0.952 kg/cm2 , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm2 , 14.69 psi).
  4. If NG, replace EVAP control system pressure sensor.