LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Frontier SL, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Control System (Qr25DE)) >> DTC/Circuit Diagnosis >> DTC P0181: FTT Sensor >> Component Function Check

Component Function Check

WARNING: This page is about a different car, the 2011 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUEL TANK TEMPERATURE (FTT) SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect fuel level sensor unit and fuel pump harness connector.
    3. Remove fuel level sensor unit. Refer to "REMOVAL AND INSTALLATION ".
    4. Check resistance between fuel level sensor unit and fuel pump terminals by heating with hot water as shown in the figure.
      RESISTANCE REFERENCE

      Terminals Condition Resistance (kΩ)
      2 and 4 Temperature [°C (°F)] 20 (68) 2.3 - 2.7
      50 (122) 0.79 - 0.90
      Fig 1: Checking Resistance Between Fuel Level Sensor Unit And Fuel Pump Terminals
      G07118550Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: Go to 2.

      NO: Proceed to "DIAGNOSIS PROCEDURE ".

  2. CHECK INTERMITTENT INCIDENT

    Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Proceed to "DIAGNOSIS PROCEDURE ".