LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Frontier SL, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Control System (Qr25DE)) >> DTC/Circuit Diagnosis >> DTC P0116: ECT Sensor >> Component Function Check

Component Function Check

WARNING: This page is about a different car, the 2011 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ENGINE COOLANT TEMPERATURE (ECT) SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect ECT sensor harness connector.
    3. Remove ECT sensor. Refer to "REMOVAL AND INSTALLATION ".
    4. Check resistance between ECT sensor terminals by heating with hot water as shown in the figure.
      RESISTANCE REFERENCE

      Terminals Condition Resistance (kΩ)
      1 and 2 Temperature [°C (°F)] 20 (68) 2.10 - 2.90
      50 (122) 0.68 - 1.00
      90 (194) 0.236 - 0.260
      Fig 1: Checking Resistance Between ECT Sensor Terminals
      G07118463Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: Go to 2.

      NO: Proceed to "DIAGNOSIS PROCEDURE ".

  2. CHECK INTERMITTENT INCIDENT

    Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Proceed to "DIAGNOSIS PROCEDURE ".