LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Frontier SL, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0181 To P0550 (VQ40DE) >> DTC P0442: EVAP Control System >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

WITH CONSULT

  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
  4. Check that the following conditions are met.

    COOLAN TEMP/S: 0 - 70°C (32 - 158°F) 

    INT/A TEMP SE: 0 - 30°C (32 - 86°F) 

  5. Select "EVP V/S LEAK P0456/P1456" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.

    Follow the instructions displayed.

    NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT screen, go to "BASIC INSPECTION ".
  6. Check that "OK" is displayed.

    If "NG" is displayed, refer to "DIAGNOSIS PROCEDURE ".

    NOTE: Check that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

WITH GST

NOTE: Be sure to read the explanation of Driving Pattern ON "SRT SET DRIVING PATTERN " before driving vehicle.
  1. Start engine.
  2. Drive vehicle according to Driving Pattern, "DIAGNOSIS DESCRIPTION: DRIVING PATTERN ".
  3. Stop vehicle.
  4. Turn ignition switch OFF, wait at least 10 seconds.
  5. Turn ignition switch ON.
  6. Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
  7. Select Service $07 with GST.