Diagnosis Procedure
- CHECK ASCD STEERING SWITCH CIRCUIT
With CONSULT
- Turn ignition switch ON.
- Select "MAIN SW", "CANCEL SW", "RESUME/ACC SW" and "SET SW" in "DATA MONITOR" mode with CONSULT.
- Check each item indication under the following conditions.MONITOR ITEM CONDITION CHART
Monitor item Condition Indication MAIN SW MAIN switch Pressed ON Released OFF CANCEL SW CANCEL switch Pressed ON Released OFF RESUME/ACC SW RESUME/ACCELERATE switch Pressed ON Released OFF SET SW SET/COAST switch Pressed ON Released OFF
Without CONSULT
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals under the following conditions.TERMINAL VOLTAGE REFERENCE CHART
ECM Condition Voltage (V) Connector + - Terminal Terminal E16 101 (ASCD steering switch signal) 108 (ASCD steering switch ground) MAIN switch: Pressed Approx. 0 CANCEL switch: Pressed Approx. 1 SET/COAST switch: Pressed Approx. 2 RESUME/ACCELERATE switch: Pressed Approx. 3 All ASCD steering switches: Released Approx. 4 Is the inspection result normal?
YES: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".
NO: GO TO 2.
- CHECK ASCD STEERING SWITCH GROUND CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect ECM harness connector M303.
- Disconnect combination switch harness connector.
- Check the continuity between combination switch and ECM harness connector.TERMINAL CONTINUITY REFERENCE CHART
Combination switch ECM Continuity Terminal Connector Terminal 16 E16 108 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 3.
NO: Repair or replace error-detected parts.
- CHECK ASCD STEERING SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Check the continuity between combination switch and ECM harness connector.TERMINAL CONTINUITY REFERENCE CHART
Combination switch ECM Continuity Terminal Connector Terminal 13 E16 101 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 4.
NO: Repair or replace error-detected parts.
- Check the continuity between combination switch and ECM harness connector.
- CHECK ASCD STEERING SWITCH
Check ASCD steering switch. Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".
NO: Replace ASCD steering switch. Refer to "ENGINE CONTROL SYSTEM : COMPONENT PARTS LOCATION ".