LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Quest LE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0137 To P0448 >> DTC P0335: CKP Sensor (Pos) >> Component Inspection

Component Inspection

  1. CHECK CRANKSHAFT POSITION SENSOR (POS)-I
    1. Loosen the fixing bolt of the sensor.
    2. Disconnect crankshaft position sensor (POS) harness connector.
    3. Remove the sensor.
    4. Visually check the sensor for chipping.

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Replace crankshaft position sensor (POS). Refer to "EXPLODED VIEW ".

      Fig 1: Checking Crankshaft Position Sensor Chipping
      G04886527Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK CRANKSHAFT POSITION SENSOR (POS)-II

    Check resistance crankshaft position sensor (POS) terminals as per the following.

    TERMINALS RESISTANCE REFERENCE CHART

    Terminal No. (Polarity) Resistance
    1 (+) - 2 (-) Except 0 or ∞ Ω [at 25°C (77°F)]
    1 (+) - 3 (-)
    2 (+) - 3 (-)

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace crankshaft position sensor (POS). Refer to "EXPLODED VIEW ".