LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Driver Information System) >> Service Information >> Combination Meters >> Power Supply and Ground Circuit Inspection

Power Supply and Ground Circuit Inspection

WARNING: This page is about a different car, the 2009 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUSE

    Check for blown combination meter fuses.

    FUSE SPECIFICATION

    Power source Fuse No.
    Battery 19
    Ignition switch ON or START 14
    Ignition switch ACC or ON 6

    OK or NG 

    OK: GO TO 2.

    NG: Be sure to eliminate cause of malfunction before installing new fuse. Refer to POWER SUPPLY ROUTING CIRCUIT .

  2. CHECK POWER SUPPLY CIRCUIT

    Check voltage between combination meter harness connector terminals and ground.

    TERMINAL VOLTAGE REFERENCE

    Terminals Ignition switch position
    (+) (-) OFF ACC ON
    Combination meter connector Terminal
    M24 1 Ground Battery voltage Battery voltage Battery voltage
    2 0V 0V Battery voltage
    23 0V Battery voltage Battery voltage
    Fig 1: Checking Voltage Between Combination Meter Harness Connector Terminals And Ground
    G04928410Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 3.

    NG: Repair harness or connector.

  3. CHECK GROUND CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector.
    3. Check continuity between combination meter harness connector terminals and ground.
      TERMINAL CONTINUITY REFERENCE

      Combination meter connector Terminal Ground Continuity
      M24 3 Yes
      21
      22
      Fig 2: Checking Continuity Between Combination Meter Harness Connector Terminals And Ground
      G04928411Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".

      NG: Repair harness or connector.