LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Axle >> Front Drive Shaft >> Disassembly and Assembly (Left Side) >> Assembly >> Transaxle Side

Transaxle Side

  1. Install new boot and new small boot band on shaft.
    CAUTION:
    • Do not reuse boot or boot band.
    • Cover drive shaft serration with tape to prevent damage to boot during installation.
  2. Remove protective tape wound around serrated part of shaft.
    Fig 1: Covering Drive Shaft Serration With Tape
    G04876506
  3. Align matching mark on spider assembly with matching mark on shaft and install spider assembly with chamfer facing shaft.
    Fig 2: Identifying Matching Mark On Spider Assembly
    G04921465
  4. Install new snap ring using a suitable tool.
    CAUTION: Do not reuse snap ring.
  5. Apply recommended grease (Genuine NISSAN Grease or equivalent) to spider assembly and sliding surface.
  6. Install the slide joint housing onto the spider assembly and pack with the balance of recommended grease (Genuine NISSAN Grease or equivalent).

    Grease amount : 130 - 140 g (4.6 - 4.9 oz.) 

    Fig 3: Identifying Boot Installation Length
    G04927171
  7. Install boot securely into grooves (indicated by * marks) as shown.
    CAUTION: If there is grease on boot mounting surfaces (indicated by * marks) of shaft and housing, boot may come off. Clean all grease from surfaces.
  8. Make sure boot installation length "L" is the length specified below. Insert a flat-bladed screwdriver or similar tool into the large end of boot. Bleed air from boot to prevent boot deformation.
    Fig 4: Identifying Boot Installation Length
    G04927172

    Boot installation length "L " 

    M/T models : 181.2 mm (7.13 in) 

    CVT models : 176.0 mm (6.93 in) 

    CAUTION:
    • Boot may break if boot installation length is outside the standard value.
    • Be careful that screwdriver tip does not contact inside surface of boot.
  9. Secure large end of boot with new boot band.
    1. Set boot band onto boot and insert first pawl on boot band into the first groove on opposite end of boot band.
    2. Pull and tighten the boot band using suitable tool until both pawls of boot band are secured in the boot band grooves.
      CAUTION: Do not reuse boot band.
      Fig 5: Tightening Boot Band
      G04902012
  10. Install new small boot band securely using Tool.

    Tool number : KV40107300 ( - ) 

    CAUTION:
    • Do not reuse boot band.
    • Secure boot band so that dimension "M" meets specification as shown.

      Dimension "M" : 1.0 - 4.0 mm (0.039 - 0.157 in)

      Fig 6: Identifying Small Boot Band
      G04902013
  11. Rotate the slide joint and confirm that the boot position is correct. If boot position is not correct, remove the boot bands, reposition the boot and install new boot bands.
  12. Install new dust shield to slide joint housing.
    CAUTION: Do not reuse dust shield.