LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2006 >> Sentra SE-R Spec V >> Repair and Diagnosis >> Transmission >> Manual Transmission >> RS6F51H >> Transaxle Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove the air cleaner and air duct.
  2. Remove the battery.
  3. Remove the air breather hose.
  4. Remove the clutch operating cylinder.
    CAUTION: Do not depress the clutch pedal during the removal procedure.
  5. Remove the engine under cover.
  6. Disconnect the control cable from the transaxle. Refer to "REMOVAL AND INSTALLATION OF CONTROL DEVICE AND CABLE ".
  7. Drain the gear oil from the transaxle. Refer to "CHANGING M/T OIL ".
  8. Remove the connectors and harnesses for:
    • PNP switch
    • Speed sensor
    • Back-up lamp switch
    • Ground
  9. Remove the exhaust front tube. Refer to "REMOVAL AND INSTALLATION ".
  10. Remove the drive shaft. Refer to "REMOVAL ".
  11. Remove the starter motor. Refer to "REMOVAL AND INSTALLATION ".
  12. Place a suitable jack under the transaxle.
    CAUTION: When setting the jack, be careful not to bring it into contact with the switches.
  13. Remove the center member, engine insulator, and engine mount bracket.
  14. Support the engine by placing a jack under the engine oil pan.
  15. Fig 1: Supporting Engine By Placing Jacking Under Engine Oil Pan
    G04192641Courtesy of NISSAN MOTOR CO., U.S.A.
  16. Remove the bolts that mount the engine to the transaxle.
  17. Remove the transaxle from the vehicle as shown.