Removal and Installation: Removal
- Disconnect the negative battery terminal.
- Remove the air cleaner and air duct. Refer to "REMOVAL AND INSTALLATION ".
- Disconnect the clutch operating cylinder from the transaxle and position aside. Refer to "REMOVAL ".
- Disconnect back-up lamp switch, VSS sensor, PNP switch, and ground harness connectors.
- Remove the starter motor. Refer to "REMOVAL ".
- Remove the air breather hose.
- Remove the shift control rod and support rod from transaxle.
- Remove the drain plug and drain the gear oil from the transaxle.
- Remove the drive shafts from the transaxle. Refer to "REMOVAL ".
- Support the engine by placing a jack under the oil pan as shown.
CAUTION: Do not place the jack under the oil pan drain plug.
- Remove LH side and rear side mounting bolts.
- Remove the lower housing bolts.
- Remove the bolts securing the transaxle to the engine.
- Lower the transaxle while supporting it with the jack.