MAINSHAFT And Gears: Inspection: Synchronizers
- Check spline area of coupling sleeves, hubs and gears for wear or cracks.
- Check baulk rings for cracks or deformation.
- Check insert springs for wear or deformation.
- If any crack, damage, or excessive wear is found on cam face of baulk ring or working face of insert, replace it.
- Measure the movement (play, dimension "L") of 1st & 2nd coupling sleeve and 5th & reverse coupling sleeve with their end fixed and the other end lifted as shown in the figure. If the movement exceeds specification, replace the sleeve.COUPLING SLEEVE - LENGTH DIMENSION
Coupling sleeve Length "L" 1st & 2nd 0 - 0.68 mm (0 - 0.0268 in) 5th & Reverse 0 - 0.89 mm (0 - 0.0350 in) - Measure clearance between baulk ring and gear. Refer to "CLEARANCE BETWEEN BAULK RING AND GEAR ".