MAINSHAFT And Gears: Assembly
- Install 1st gear needle bearing and 1st main gear onto mainshaft.
- Install 1st double cone assembly onto mainshaft.
- Install 1st & 2nd synchronizer hub with its three grooves facing the front side (1st main gear side) onto mainshaft.CAUTION: Do not reuse 1st & 2nd synchronizer hub.
- Install 1st & 2nd synchronizer hub using Tool.
- Install insert spring onto 1st & 2nd coupling sleeve.
- Install 1st & 2nd coupling sleeve with its chamfered surface facing the 1st main gear side onto 1st & 2nd synchronizer hub.
- Install 2nd gear bushing with its flange surface facing 1st & 2nd synchronizer hub side using Tool.
- Install 2nd needle bearing, 2nd double cone assembly, and 2nd main gear onto mainshaft using Tool.
- Position 3rd main gear as shown, and install it using Tool.CAUTION: Do not reuse 3rd main gear.
- Install spacer and mainshaft adjusting shim onto mainshaft.
- Select a mainshaft adjusting shim suitable to satisfy the following specification of dimension "L" and install it onto mainshaft.
Dimension "L": 151.35 -151.45 mm (5.9586 - 5.9626 in)
Mainshaft adjusting shims : Refer to "AVAILABLE ADJUSTING SHIMS ".
- Position 4th main gear as shown, and install it onto mainshaft.
- Install 4th main gear onto mainshaft using Tool.CAUTION: Do not reuse 4th main gear.
- Install 5th gear bushing with its flange surface facing the 4th main gear side using Tool.
- Install 5th needle bearing, 5th main gear, and 5th gear baulk ring onto mainshaft.
- Being careful of the following points, install spread spring, shifting insert, and 5th & reverse synchronizer hub onto 5th & reverse coupling sleeve.
Courtesy of NISSAN MOTOR CO., U.S.A.
- Pay attention to the shape of spread spring and shifting insert for correct assembly.
Do not install spread spring hook onto the same shifting insert.
- Install synchronizer hub with its three grooves facing the front side (5th main gear side).CAUTION: Do not reuse 5th & reverse synchronizer hub.
- Install 5th & reverse coupling sleeve with its chamfered surface facing the reverse main gear side.
- Pay attention to the shape of spread spring and shifting insert for correct assembly.
- Install 5th & reverse synchronizer hub assembly using Tool.
- Install reverse gear baulk ring using Tool.
- Install reverse gear bushing using Tool.
- Install reverse gear needle bearing using Tool.
- Install sub-gear, sub-gear washer, and snap ring onto reverse main gear.CAUTION:
- Pay attention to direction of sub-gear washer.
- Do not reuse snap ring.
- Install reverse main gear assembly onto mainshaft.
- Select a thrust washer suitable to satisfy the following specification of dimension "M" as shown, and install it onto mainshaft.
Dimension "M": 244.20 - 244.30 mm(9.6142 - 9.6181 in)
Available thrust washers : Refer to "AVAILABLE THRUST WASHER ".
- Install mainshaft rear bearing using Tool.
- Install mainshaft C-ring.
- Using feeler gauge, measure the end play of mainshaft rear bearing with a suitable tool, and check if it satisfies the following specification.
End play: 0 - 0.06 mm (0 - 0.0024 in)
Mainshaft C-rings : Refer to "AVAILABLE C-RINGS ".
- Install C-ring holder.
- Install snap ring with a suitable tool.
- Measure gear end play as a final check. Refer to "GEAR END PLAY ".