LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2006 >> Sentra SE-R Spec V >> Repair and Diagnosis >> Transmission >> Manual Transmission >> RS5F70A >> Input Shaft And Gears >> Disassembly

Input Shaft And Gears: Disassembly

  1. Before disassembly, measure the end plays of 3rd and 4th input gears with a suitable tool. Refer to "GEAR END PLAY ".
    • If end play is not within specification, disassemble and check the parts.
    Fig 1: Measuring End Plays Of 3rd And 4th Input Gears
    G04192523Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Remove oil channel from input shaft rear bearing.
    Fig 2: Removing Oil Channel From Input Shaft Rear Bearing
    G04192524Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Press out input shaft rear bearing using Tool.
    Fig 3: Pressing Out Input Shaft Rear Bearing Using Tool
    G04192525Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove C-ring holder.
  5. Remove 5th gear rear C-ring.
    Fig 4: Removing 5th Gear C-Ring & Holder
    G04192526Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Remove 5th input gear from input shaft using Tool.
  7. Remove 5th gear front C-ring.
    Fig 5: Removing 5th Input Gear From Input Shaft Using Tool
    G04192527Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Remove 4th input gear, baulk ring, 4th gear needle bearing, and 4th gear C-ring from input shaft.
  9. Press out both 3rd & 4th synchronizer hub assembly and 3rd input gear from input shaft using Tool.
  10. Remove 3rd gear needle bearing.
    Fig 6: Pressing Out Both 3rd And 4th Synchronizer Hub Assembly And 3rd Input Gear
    G04192528Courtesy of NISSAN MOTOR CO., U.S.A.
  11. Press out input shaft front bearing from input shaft using Tool.
    Fig 7: Pressing Out Input Shaft Front Bearing From Input Shaft Using Tool
    G04192529Courtesy of NISSAN MOTOR CO., U.S.A.