LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2005 >> Altima Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System - Qr25DE >> Trouble Diagnosis >> CONSULT-II Function (ENGINE) >> Inspection Procedure

Inspection Procedure

  1. Turn ignition switch OFF.
  2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located under LH dash panel.
  3. Turn ignition switch ON.
    Fig 1: Connecting Data Link Connector
    G02523926Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Touch "START" (NISSAN BASED VHCL).
    Fig 2: Consult-II - Data Display
    G02523927Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Touch "ENGINE".

    If "ENGINE" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

    Fig 3: Select System - Display
    G02523928Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Perform each diagnostic test mode according to each service procedure.

    For further information, see the CONSULT-II Operation Manual. 

    Fig 4: Select Diag Mode System - Display
    G02523929Courtesy of NISSAN MOTOR CO., U.S.A.