LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2005 >> Altima Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System - Qr25DE >> DTC P1805: Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Disconnect stop lamp switch harness connector.
    Fig 1: Identifying Stop Lamp Switch
    G02526957Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    CONDITION AND CONTINUITY REFERENCE

    Conditions Continuity
    Brake pedal fully released Should not exist.
    Brake pedal depressed Should exist.

    If NG, adjust brake pedal installation, refer to "BRAKE PEDAL ", and perform step 2 again.

    Fig 2: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G02526958Courtesy of NISSAN MOTOR CO., U.S.A.