LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2005 >> Altima Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System - Qr25DE >> DTC P1564: ASCD Steering Switch >> Diagnostic Procedure

Diagnostic Procedure

  1. CHECK ASCD STEERING SWITCH CIRCUIT 

    With CONSULT-II 

    1. Turn ignition switch ON.
    2. Select "MAIN SW", "RESUME/ACC SW", "SET SW and "CANCEL SW" in "DATA MONITOR" mode with CONSULT-II.
    3. Check each item indication under the following conditions.
      Fig 1: Monitor Item And Condition Chart
      G02526895Courtesy of NISSAN MOTOR CO., U.S.A.
      Fig 2: Display Data Monitor Mode Screen
      G02526896Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    1. Turn ignition switch ON.
    2. Check voltage between ECM terminal 99 and ground with pressing each button.
      Fig 3: Switches Voltage Specification Chart
      G02526897Courtesy of NISSAN MOTOR CO., U.S.A.
      Fig 4: Checking Voltage Between ECM Terminal 99 And Ground
      G02526898Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG

      • OK: GO TO  7.
      • NG: GO TO 2.
  2. CHECK ASCD STEERING SWITCH GROUND CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect combination switch harness connector M102.
    3. Disconnect ECM harness connector.
    4. Check harness continuity between combination switch terminal 19 and ECM terminal 67.

      Refer to WIRING DIAGRAM .

      Continuity should exist. 

    5. Also check harness for short to ground or short to power.

    OK or NG

    • OK: GO TO  4.
    • NG: GO TO 3.
      Fig 5: Identifying ASCD Steering Switch
      G02526899Courtesy of NISSAN MOTOR CO., U.S.A.
  3. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors M71, F59
    • Combination switch (spiral cable)
    • Harness for open and short between ECM and combination switch

    : Repair open circuit or short to ground or short to power in harness or connectors.

  4. CHECK ASCD STEERING SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Check harness continuity between ECM terminal 99 and combination switch terminal 20.

      Refer to WIRING DIAGRAM .

      Continuity should exist. 

    2. Also check harness for short to ground and short to power.

    OK or NG

    • OK: GO TO  6.
    • NG: GO TO 5.
  5. DETECT MALFUNCTIONING PART 

    Check the following.

    • Combination switch (spiral cable)
    • Harness for open and short between ECM and combination switch
    • Harness connectors M71, F59

      : Repair open circuit or short to ground or short to power in harness or connectors.

  6. CHECK ASCD STEERING SWITCH 

    Refer to "COMPONENT INSPECTION ".

    OK or NG

    • OK: GO TO 7.
    • NG: Replace ASCD steering switch.
  7. CHECK INTERMITTENT INCIDENT 

    Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

    : INSPECTION END