LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2005 >> Altima Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System - Qr25DE >> DTC P0442: EVAP Control System >> DIAGNOSTIC TROUBLE CODES Confirmation Procedure >> With Consult-II

With Consult-II

  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  4. Check the following conditions are met.

    COOLAN TEMP/S: 0 - 70°C (32 - 158°F) 

    INT/A TEMP SE: 0 - 30°C (32 - 86°F) 

  5. Select "EVAP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.

    Follow the instruction displayed.

    Fig 1: Display - DATA MONITOR Mode With CONSULT-II
    G02525097Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 2: Display - EVAP SML LEAK P0442/P1442 Of EVAPORATIVE SYSTEM In DTC WORK SUPPORT Mode With CONSULT-II
    G02525098Courtesy of NISSAN MOTOR CO., U.S.A.
    NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-II screen, go to "BASIC INSPECTION ".
  6. Make sure that "OK" is displayed.

If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE ".

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
Fig 3: Display - EVAP SML LEAK P0442/P1442
G02525099Courtesy of NISSAN MOTOR CO., U.S.A.