LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2005 >> Altima Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System - Qr25DE >> DTC P0101: MAF Sensor >> DIAGNOSTIC TROUBLE CODES Confirmation Procedure >> With CONSULT-II

With CONSULT-II

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Start engine and warm it up to normal operating temperature.
  4. Run engine for at least 10 seconds at idle speed.
  5. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "
Fig 1: Display - DATA MONITOR Mode With CONSULT-II
G02524880Courtesy of NISSAN MOTOR CO., U.S.A.


  1. Turn ignition switch ON.
  2. Start engine and warm it up to normal operating temperature.

    If engine cannot be started, go to "DIAGNOSTIC PROCEDURE ".

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Check the voltage of "MAS A/F SE-B1" with "DATA MONITOR".
  5. Increases engine speed to about 4,000 RPM.
  6. Monitor the linear voltage rise in response to engine speed increases.

    If NG, go to "DIAGNOSTIC PROCEDURE ".

    If OK, go to following step.

    Fig 1: MAS A/F SE-B1 Voltage Graph
    G02524881Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Maintain the following conditions for at least 10 consecutive seconds.
    CONDITIONS

    ENG SPEED More than 2,000 RPM
    THRTL SEN 1 More than 3V
    THRTL SEN 2 More than 3V
    Selector lever Suitable position
    Driving location Driving vehicle uphill
    (Increased engine load) will help maintain the driving conditions required for this test.
  8. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "
Fig 2: Display - DATA MONITOR Mode
G02524882Courtesy of NISSAN MOTOR CO., U.S.A.