LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 746 (Engine Cooling System) >> Engine Coolant >> Changing Engine Coolant >> Refilling Engine Coolant

Refilling Engine Coolant

WARNING: This page is about a different car, the 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install reservoir tank if removed, and radiator drain plug.
    1. Radiator drain plug:  

      0. 78 - 1. 6 N. m (0. 08 - 0. 16 kg-m, 7 - 14 in-lb) 

  2. Install cylinder block drain plugs if removed.
    • Apply thread sealant to the thread of cylinder drain plugs.

      Use Genuine Thread Sealant or equivalent. Refer to " RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS  "  .

      1. Cylinder block drain plug:  

        14. 7 - 24. 5 N. m (1. 5 - 2. 5 kg-m, 11 - 18 ft-lb) 

  3. Fill radiator and reservoir tank to specified level.
    Fig 1: Identifying Reservoir Tank Level
    G02021103Courtesy of NISSAN MOTOR CO., U.S.A.
    • Use genuine Nissan anti-freeze engine coolant or equivalent mixed with water (distilled or demineralized). Refer to " RECOMMENDED FLUIDS AND LUBRICANTS  ". 
      1. Engine coolant capacity (With reservoir tank):  

        Approximately 9. 8 l (10-3/8 US qt, 8-5/8 Imp qt) 

      2. Reservoir tank capacity:  

        0. 8 l (7/8 US qt, 3/4 Imp qt) 

    • Pour engine coolant through engine coolant filler neck slowly of less than 2 l (2-1/8 US qt, 1-3/4 Imp qt) a minute to allow air in system to escape.  
    • When engine coolant overflows air relief hole on heater hose, install air relief plug.
  4. Warm up engine to normal operating temperature with radiator cap installed.
    Fig 2: Locating Min And Max Coolant Level
    G02021104Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Run engine at 3,000 rpm for 10 seconds and return to idle speed.
    • Repeat two or three times.

    Watch engine coolant temperature gauge so as not to overheat the engine.  

  6. Stop engine and cool down to less than approximately 50°C (122°F).
    • Cool down using a fan to reduce the time.
    • If necessary, refill radiator up to filler neck with engine coolant.
  7. Refill reservoir tank to MAX level line with engine coolant.
  8. Repeat steps  3 through  6 two or more times with radiator cap installed until engine coolant level no longer drops.
  9. Check cooling system for leaks with engine running.
  10. Warm up engine, and check for sound of engine coolant flow while running engine from idle up to 3,000 rpm with heater temperature controller set at several position between COOL and WARM.
    • Sound may be noticeable at heater unit.
  11. Repeat step  8 three times.
  12. If sound is heard, bleed air from cooling system by repeating steps  3 through  6 until engine coolant level no longer drops.
    • Clean excess engine coolant from engine.