LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Engine Lubrication System) >> Precautions >> Precautions For Liquid Gasket >> Liquid Gasket Application Procedure

Liquid Gasket Application Procedure

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a scraper, remove the old sealant adhering to the mating surface.
    • Remove the sealant completely from the groove, mounting bolts, and bolt holes.
  2. Thoroughly clean the mating surface removing any adhering moisture, grease and foreign material.
  3. Attach the sealant tube to the Tool.
    1. Tool number : WS39930000 ( - ) 

    Use Genuine RTV Silicone Sealant or equivalent. See RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS in GENERAL INFORMATION - TITAN article in GENERAL INFORMATION.

    Fig 1: Remove The Old Sealant
    G00343638Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Apply the sealant without breaks to the specified location with the specified dimensions.
    • If there is a groove for the sealant application, apply the sealant to the groove.
      Fig 2: Applying The Sealant
      G00343639Courtesy of NISSAN MOTOR CO., U.S.A.
    • As for the bolt holes, normally apply the sealant inside the holes. Occasionally, it should be applied outside the holes.
    • Within five minutes of sealant application, install the mating component.
    • If the sealant protrudes, wipe it off immediately.
    • Do not retighten after the installation.
    • After 30 minutes or more have passed from the installation, fill the engine with the proper oil and coolant.
      Fig 3: Applying The Sealant Inside The Holes
      G00343640Courtesy of NISSAN MOTOR CO., U.S.A.