LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Drive Positioner) >> Automatic Drive Positioner >> Seat Memory Indicator Lamp Circuit Inspection

Seat Memory Indicator Lamp Circuit Inspection

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUNCTION 

    With CONSULT-II 

    With "MEMORY SW INDCTR" in ACTIVE TEST, check operation.

    CHECK FUNCTION

    Test item Description
    MEMORY SW INDCTR The memory switch indicator is lit by receiving the drive signal.
    Fig 1: Display Active Test
    G03500421Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    GO TO 2.

    OK or NG

    1. OK: Seat memory switch indicator lamp circuit is OK.
    2. NG: GO TO 2.
  2. CHECK SEAT MEMORY SWITCH POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect seat memory switch.
    3. Check voltage between seat memory switch connector D5 terminal 5 (BR/Y) and ground.
    1. 5 (BR/Y) - Ground: Battery voltage 
    Fig 2: Checking Voltage Between Seat Memory Switch Connector & Ground
    G03500422Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG

    1. OK: GO TO 3.
    2. NG: Repair or replace harness.
  3. CHECK SEAT MEMORY INDICATOR CIRCUIT HARNESS CONTINUITY 
    1. Disconnect automatic drive positioner control unit.
    2. Check continuity between automatic drive positioner control unit connector M41 terminals 12 (GR/L), 13 (Y) and seat memory switch connector D5 terminals 6 (GR/L), 7 (Y/G).
      1. 12 (GR/L)-6 (GR/L): Continuity should exist. 
      2. 13 (Y)-7 (Y/G): Continuity should exist. 
    3. Check continuity between automatic drive positioner control unit connector M41 terminals 12 (GR/L), 13 (Y) and ground.
      1. 12 (GR/L) - Ground: Continuity should not exist. 
      2. 13 (Y) - Ground: Continuity should not exist. 

      OK or NG

      1. OK: GO TO 4.
      2. NG: Repair or replace harness.
      Fig 3: Checking Continuity Between Automatic Drive Positioner Control Unit Connector & Ground
      G03500423Courtesy of NISSAN MOTOR CO., U.S.A.
  4. CHECK SEAT MEMORY SWITCH INDICATOR SIGNAL 

    Check voltage between automatic drive positioner control unit connector M41 terminals 12 (GR/L), 13 (Y) and ground.

    1. 12 (GR/L) - Ground: Battery voltage 
    2. 13 (Y) - Ground: Battery voltage 

    OK or NG

    1. OK: Replace automatic drive positioner control unit.
    2. NG: Replace seat memory switch.
    Fig 4: Checking Voltage Between Automatic Drive Positioner Control Unit Connector & Ground
    G03500424Courtesy of NISSAN MOTOR CO., U.S.A.