LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Drive Positioner) >> Automatic Drive Positioner >> Reclining Motor LH Circuit Inspection

Reclining Motor LH Circuit Inspection

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK SEAT RECLINING MECHANISM 

    Check the following.

    • Operation malfunction caused by an interference with the center pillar or center console
    • Operation malfunction and interference with other parts by poor installation

    OK or NG

    1. OK: GO TO 2.
    2. NG: Repair the malfunctioning part and check again.
  2. CHECK FUNCTION 

    With CONSULT-II 

    Check operation with "SEAT RECLINING" in ACTIVE TEST.

    CHECK FUNCTION

    Test item Description
    SEAT RECLINING The reclining motor LH is activated by receiving the drive signal.
    Fig 1: Display ACTIVE TEST
    G03500340Courtesy of NISSAN MOTOR CO., U.S.A.

    GO TO 3.

    OK or NG

    1. OK: Reclining motor LH circuit is OK.
    2. NG: GO TO 3.
  3. CHECK RECLINING MOTOR CIRCUIT HARNESS CONTINUITY 
    1. Turn ignition switch OFF.
    2. Disconnect driver seat control unit and reclining motor LH.
    3. Check continuity between driver seat control unit connector P3 terminals 36 (R/W), 44 (G/W) and reclining motor LH connector P5 terminals 3 (G/W), 4 (R/W).
      1. 36 (R/W) - 4 (R/W): Continuity should exist. 
      2. 44 (G/W) - 3 (G/W): Continuity should exist. 
    4. Check continuity between driver seat control unit connector P3 terminals 36 (R/W), 44 (G/W) and ground.
      1. 36 (R/W) - Ground: Continuity should not exist. 
      2. 44 (G/W) - Ground: Continuity should not exist. 

      OK or NG

      1. OK: GO TO 4.
      2. NG: Repair or replace harness.
      Fig 2: Checking Continuity Between Driver Seat Control Unit Connector & Ground
      G03500341Courtesy of NISSAN MOTOR CO., U.S.A.
  4. CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL 
    1. Connect the driver seat control unit and reclining motor LH.
    2. Check voltage between driver seat control unit connector and ground.
    CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL

    Connector Terminals (Wire color) Condition Voltage (V) (Approx)
    (+) (-)
    P3 36 (R/W) Ground Reclining switch ON (FR operation) Battery voltage
    Reclining switch OFF 0
    44 (G/W) Reclining switch ON (RR operation) Battery voltage
    Reclining switch OFF 0
    Fig 3: Checking Voltage Between Driver Seat Control Unit Connector & Ground
    G03500342Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG

    1. OK: Replace reclining motor LH.
    2. NG: Replace driver seat control unit.