LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Drive Positioner) >> Automatic Drive Positioner >> Pedal Adjusting Sensor Circuit Inspection

Pedal Adjusting Sensor Circuit Inspection

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUNCTION 

    With CONSULT-II 

    Operate the pedal adjusting switch with "PEDAL SEN" on the DATA MONITOR to make sure the voltage changes.

    CHECK FUNCTION

    Monitor item [OPERATION or UNIT] Contents
    PEDAL SEN "V" The pedal adjusting position (voltage) judged from the pedal adjust sensor signal is displayed.

    Without CONSULT-II 

    1. Turn ignition switch OFF.
    2. Check voltage between automatic drive positioner control unit connector and ground.
      Fig 1: Terminal Signal
      G03500374Courtesy of NISSAN MOTOR CO., U.S.A.
    CHECK FUNCTION

    Connector Terminals (Wire color) Condition Voltage (V) (Approx)
    (+) (-)
    M41 8 (W/R) Ground Pedal front end position 0.5
    Pedal back end position 4.5

    OK or NG

    1. OK: Pedal adjusting sensor circuit is OK.
    2. NG: GO TO 2.
    Fig 2: Checking Voltage Between Automatic Drive Positioner Control Unit Connector & Ground
    G03500375Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK PEDAL ADJUSTING SENSOR CIRCUIT HARNESS CONTINUITY 
    1. Disconnect automatic drive positioner control unit and pedal adjusting sensor.
    2. Check continuity between automatic drive positioner connector M41, M42 terminals 8 (W/R), 33 (W/L), 41 (V) and pedal adjusting sensor connector E110 terminals 1 (W/L), 2 (W/R), 3 (V).
      1. 8 (W/R) - 2 (W/R): Continuity should exist. 
      2. 33 (W/L) -1 (W/L): Continuity should exist. 
      3. 41 (V) - 3 (V): Continuity should exist. 
    3. Check continuity between automatic drive positioner control unit connector M41, M42 terminals 8 (W/R), 33 (W/L), 41 (V) and ground.
      1. 8 (W/R) - Ground: Continuity should not exist. 
      2. 33 (W/L) - Ground: Continuity should not exist. 
      3. 41 (V) - Ground: Continuity should not exist. 

    OK or NG

    1. OK: Replace pedal adjusting motor.
    2. NG: Repair or replace harness.
    Fig 3: Checking Continuity Between Automatic Drive Positioner Connector & Pedal Adjusting Sensor Connector
    G03500376Courtesy of NISSAN MOTOR CO., U.S.A.