LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Drive Positioner) >> Automatic Drive Positioner >> Lifting Sensor (Rear) Circuit Inspection

Lifting Sensor (Rear) Circuit Inspection

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK REAR END LIFTING SENSOR INPUT/OUTPUT SIGNAL 

    With CONSULT-II 

    Check operation with "LIFT RR PULSE" on the DATA MONITOR to make sure pulse changes.

    CHECK REAR END LIFTING SENSOR INPUT/OUTPUT SIGNAL

    Monitor item [OPERATION or UNIT] Contents
    LIFT RR PULSE - The rear lifting Position (pulse) judged from the lifting sensor (rear) is displayed.
    Fig 1: Display DATA MONITOR
    G03500370Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    1. Turn ignition switch OFF.
    2. Check signal between driver seat control unit connector and ground, with oscilloscope.
      Fig 2: Terminal Signal
      G03500371Courtesy of NISSAN MOTOR CO., U.S.A.
      Fig 3: Checking Signal Between Driver Seat Control Unit Connector & Ground
      G03500372Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG

    1. OK: Rear lifting sensor circuit is OK.
    2. NG: GO TO 2.
  2. CHECK REAR LIFTING SENSOR CIRCUIT HARNESS CONTINUITY 
    1. Disconnect driver seat control unit and lifting motor (rear).
    2. Check continuity between driver seat control unit connector P2 terminals 10 (L/Y), 16 (L), 31 (Y) and lifting motor (rear) connector P7 terminals 1 (Y), 2 (L/Y), 3 (L).
      1. 10 (L/Y) - 2 (L/Y): Continuity should exist. 
      2. 16 (L) - 3 (L): Continuity should exist. 
      3. 31 (Y) -1 (Y): Continuity should exist. 
    3. Check continuity between driver seat control unit connector P2 terminals 10 (L/Y), 31 (Y) and ground.
      1. 10 (L/Y) - Ground: Continuity should not exist. 

      OK or NG

      1. OK: Replace lifting motor (rear).
      2. NG: Repair or replace harness.
      Fig 4: Checking Continuity Between Driver Seat Control Unit Connector & Ground
      G03500373Courtesy of NISSAN MOTOR CO., U.S.A.