LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Drive Positioner) >> Automatic Drive Positioner >> Lifting Motor (Front) Circuit Inspection

Lifting Motor (Front) Circuit Inspection

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FRONT END SEAT LIFTING MECHANISM 

    Check the following.

    • Operation malfunction caused by lifter mechanism deformation, pinched harness or other foreign materials
    • Operation malfunction caused by foreign materials adhered to the lifting motor (front) or lead screws
    • Operation malfunction and interference with other parts by installation

    OK or NG

    1. OK: GO TO 2.
    2. NG: Repair the malfunctioning part and check again.
  2. CHECK FUNCTION 

    With CONSULT-II 

    Check operation with "SEAT LIFTER FR" in ACTIVE TEST.

    CHECK FUNCTION

    Test item Description
    SEAT LIFTER FR The lifting motor (front) is activated by receiving the drive signal.
    Fig 1: Display ACTIVE TEST
    G03500343Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    GO TO 3.

    OK or NG

    1. OK: Lifting motor (front) circuit is OK.
    2. NG: GO TO 3.
  3. CHECK LIFTING MOTOR (FRONT) CIRCUIT HARNESS CONTINUITY 
    1. Turn ignition switch OFF
    2. Disconnect driver seat control unit and lifting motor (front).
    3. Check continuity between driver seat control unit connector P3 terminals 37 (Y/B), 45 (Y) and lifting motor (front) connector P6 terminals 4 (Y), 6 (Y/B).
      1. 37 (Y/B) - 6 (Y/B): Continuity should exist. 
      2. 45 (Y) - 4 (Y): Continuity should exist. 
      Fig 2: Checking Continuity Between Driver Seat Control Unit Connector & Lifting Motor (Front) Connector
      G03500344Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Check continuity between driver seat control unit connector P3 terminals 37 (Y/B), 45 (Y) and ground.
    1. 37 (Y/B) - Ground: Continuity should not exist. 
    2. 45 (Y) - Ground: Continuity should not exist. 

    OK or NG

    1. OK: GO TO 4.
    2. NG: Repair or replace harness.
    Fig 3: Checking Continuity Between Driver Seat Control Unit Connector & Ground
    G03500345Courtesy of NISSAN MOTOR CO., U.S.A.
  5. CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL 
    1. Connect the driver seat control unit and lifting motor (front).
    2. Check voltage between driver seat control unit connector and ground.
    CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL

    Connector Terminals (Wire color) Condition Voltage (V) (Approx)
    (+) (-)
    P3 37 (Y/B) Ground Lifting switch (front) ON (DOWN operation) Battery voltage
    Lifting switch (front) OFF 0
    45 (Y) Lifting switch (front) ON (UP operation) Battery voltage
    Lifting switch (front) OFF 0

    OK or NG

    1. OK: Replace lifting motor (front).
    2. NG: Replace driver seat control unit.