LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Drive Positioner) >> Automatic Drive Positioner >> Front Door Switch LH Circuit Inspection

Front Door Switch LH Circuit Inspection

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUNCTION 

    With CONSULT-II 

    Touch "BCM" with "DOOR SW DR" on the DATA MONITOR, check ON/OFF operation when the front door is open and closed.

    CHECK FUNCTION

    Monitor item [OPERATION or UNIT] Contents
    DOOR SW DR(1) "ON/OFF" Door open (ON)/door closed (OFF) status judged from the front door switch is displayed.
    (1) Refer to "DATA MONITOR ".
    Fig 1: Display DATA MONITOR
    G03500429Courtesy of NISSAN MOTOR CO., U.S.A.

    Without CONSULT-II 

    GO TO 2.

    OK or NG

    1. OK: Front door switch LH circuit is OK.
    2. NG: GO TO 2.
  2. CHECK FRONT DOOR SWITCH LH 
    1. Turn ignition switch OFF.
    2. Disconnect front door switch.
    3. Check continuity between front door switch LH connector part of door switch as follows.
    CHECK FRONT DOOR SWITCH LH

    Connector Terminals Condition Continuity
    (+) (-)
    B8 1 Ground With the front door switch LH pressed No
    With the front door switch LH released Yes

    OK or NG

    1. OK: GO TO 3.
    2. NG: Replace front door switch LH.
    Fig 2: Checking Continuity Between Front Door Switch LH Connector Part Of Door Switch Terminal
    G03500430Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK HARNESS CONTINUITY 
  1. Disconnect BCM.
  2. Check continuity between BCM connector M20 terminal 62 (GR/R) and front door switch LH connector B8 terminal 1 (GR/R).
    1. 62 (GR/R) -1 (GR/R): Continuity should exist. 
  3. Check continuity between BCM connector M20 terminal 62 (GR/R) and ground.
    1. 62 (GR/R) - Ground: Continuity should not exist. 

    OK or NG

    1. OK: Front door switch LH circuit is OK.
    2. NG: Repair or replace harness.
    Fig 3: Checking Continuity Between BCM Connector & Ground
    G03500431Courtesy of NISSAN MOTOR CO., U.S.A.