LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Automatic Drive Positioner) >> Automatic Drive Positioner >> CAN Communication Inspection Using CONSULT-II (Self-Diagnosis)

CAN Communication Inspection Using CONSULT-II (Self-Diagnosis)

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. SELF-DIAGNOSTIC RESULT CHECK 
    CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
    1. Connect to CONSULT-II, and select "AUTO DRIVE POS." on the "SELECT DIAG SYSTEM" screen.
    2. Select "SELF-DIAG RESULTS" on "SELECT DIAG MODE" screen.
    3. Check display content in self-diagnostic results.
    SELF-DIAGNOSTIC RESULT CHECK

    CONSULT-II display code Diagnosis item
    U1000 CAN COMM
    CAN CIRC 1
    CAN CIRC 2
    CAN CIRC 3
    CAN CIRC 4

    Contents displayed

    No malfunction: inspection End

    Malfunction in CAN communication system: GO TO 2.

  2. SYMPTOM CHECK 
    1. Select "CAN diagnosis support monitor" in data monitor.
    2. Select "START" and check display content.
    SYMPTOM CHECK

    Diagnosis item Self-diagnostic result content
    Normal Not normal (Example)
    CAN COMM OK NG
    CAN CIRC 1 OK UNKWN
    CAN CIRC 2 OK UNKWN
    CAN CIRC 3 OK UNKWN
    CAN CIRC 4 OK UNKWN

    : After printing the monitor items, go to "CAN System". Refer to PRECAUTIONS WHEN USING CONSULT-II .