LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 719 (Combination Meters) >> Combination Meters >> Power Supply and Ground Circuit Inspection

Power Supply and Ground Circuit Inspection

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check Fuses 

    Check that any of the fuses in combination meter is blown.

    Fig 1: Fuses Identification Chart
    G02340563Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK: Go to 2.
    2. NG: If fuse is blown, be sure to eliminate cause of problem before installing new fuse. Refer to POWER DISTRIBUTION .

  2. Check Power Supply Circuit 
    1. Disconnect combination meter connector.
    2. Check voltage between combination meter harness connector terminals and ground.
      Fig 2: Testing Power Circuits To Combination Meter
      G02340565Courtesy of NISSAN MOTOR CO., U.S.A.
      Fig 3: Combination Meter Connector Terminals Specification Chart
      G02340564Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK: Go to 3.
    2. NG: Check harness for open or short between combination meter and fuse.

  3. Check Ground Circuit 
    1. Turn ignition switch OFF.
    2. Check continuity between combination meter harness connector M41 terminals 20 (B), 33 (B) and ground.
      Fig 4: Checking Combination Meter Ground Circuit
      G02340566Courtesy of NISSAN MOTOR CO., U.S.A.
      1. Continuity should exist  .

    OK or NG 

    1. OK: Inspection end.
    2. NG: Repair harness or connector.