Diagnostic Procedure
WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DTC WITH ECM
Perform self-diagnosis with ECM. Refer to SELF-DIAG RESULTS MODE in ENGINE CONTROL SYSTEM - TITAN article in ENGINE PERFORMANCE.
Is any malfunction detected by self-diagnosis?
- YES: Check the malfunctioning system.
- NO: GO TO 2.
- CHECK TRANSFER CONTROL UNIT
Check transfer control unit input/output signal. Refer to TRANSFER CONTROL UNIT INPUT/OUTPUT SIGNAL REFERENCE VALUES .
OK or NG
- OK: GO TO 3.
- NG: Check transfer control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.
- CHECK DTC
Perform the self-diagnosis, after driving a vehicle for a while.
OK or NG
- OK: INSPECTION END
- NG: Perform self-diagnosis with ECM again. Refer to SELF-DIAG RESULTS MODE in ENGINE CONTROL SYSTEM - TITAN article in ENGINE PERFORMANCE.