LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Lighting System) >> Front Fog Lamp >> Preliminary Check >> Check Power Supply And Ground Circuit

Check Power Supply And Ground Circuit

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUSES OR FUSIBLE LINK 

    Check for blown fuses or fusible link.

    FUSES OR FUSIBLE LINK INSPECTION

    Unit Power source Fuse No.
    BCM Battery f
    Ignition switch ON or START position 59
    IPDM E/R Battery 53
    Battery (Fog lamps ON) 56

    Refer to "WIRING DIAGRAM - F/FOG - ".

    OK or NG 

    • OK: GO TO 2.
    • NG: If fuse is blown, be sure to eliminate cause of blown fuse before installing new fuse. Refer to "POWER SUPPLY ROUTING CIRCUIT ".
  2. CHECK POWER SUPPLY CIRCUIT 
    1. Disconnect BCM connectors.
    2. Check voltage between BCM harness connector and ground.
      Fig 1: Checking Voltage Between BCM Harness Connector Terminals And Ground
      G03604863Courtesy of NISSAN MOTOR CO., U.S.A.
      BCM HARNESS CONNECTOR AND GROUND VOLTAGE

      Terminals Ignition switch position
      (+) (-) OFF ACC ON
      Connector Terminal (Wire color)
      M18 38 (W/L) Ground 0V 0V Battery voltage
      M20 70 (W/B) Battery voltage Battery voltage Battery voltage

    OK or NG 

    • OK: GO TO 3.
    • NG: Check harness for open between BCM and fuse.
  3. CHECK GROUND CIRCUIT 

    Check continuity between BCM harness connector and ground.

    Fig 2: Checking Continuity Between BCM Harness Connectors And Ground
    G03604864Courtesy of NISSAN MOTOR CO., U.S.A.
    BCM HARNESS CONNECTOR AND GROUND CONTINUITY

    Terminals Continuity
    Connector Terminal (Wire color)  
    M20 67 (B) Ground Yes

    OK or NG 

    • OK: Inspection End.
    • NG: Check ground circuit harness.