Rear Door Speaker Check (Base System)
WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS
- Turn ignition switch OFF
- Disconnect audio unit connector and rear door speaker connector
- Check continuity between audio unit harness connector terminal and rear door speaker harness connector terminal.CONTINUITY CHECK CHART
Terminals Continuity Audio unit Speaker Connector Terminal (Wire color) Connector Terminal (Wire color) M45 13 (B/P) D54 2 (R) Yes 14 (O) 1 (L) 15 (B/W) D74 2 (R) 16 (L) 1 (L) - Check continuity between audio unit harness connector terminal and ground.CONTINUITY CHECK CHART
Terminals Continuity Audio unit Ground Connector Terminal (Wire color) M45 13 (B/P) No 14 (O) 15 (B/W) 16 (L)
OK or NG
- OK: GO TO 2.
- NG:
- Check connector housings for disconnected or loose terminals.
- Repair harness or connector.
- CHECK REAR SPEAKER SIGNAL
- Connect audio unit connector and rear speaker connector.
- Turn ignition switch ON.
- Push "POWER" switch.
- Check the signal between audio unit harness connector terminals with CONSULT-II or oscilloscope.
OK or NG
- OK: INSPECTION END.
- NG: Replace audio unit.