Inspection/Compass And Thermometer
WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM AND POSSIBLE CAUSES
| Symptom |
Possible causes |
Repair order |
| No display at all |
- 10A fuse
- Ground circuit
- Compass and thermometer
|
- Check 10A fuse [No. 12, located in fuse block (J/B)].
Turn the ignition switch ON and verify that battery positive voltage is at terminal 2 of compass and thermometer.
- Check ground circuit for compass and thermometer.
- Replace compass and thermometer.
|
| Forward direction indication slips off the mark or incorrect |
- In manual correction mode (Bar and display vanish)
- Zone variation change is not done
|
- Drive the vehicle and turn at an angle of 90°.
- Perform the zone variation change.
|
| Compass reading remains unchanged |
- Vehicle speed signal is not entered
- Compass and thermometer
|
- Check harness for open or short between combination meter terminal 29 and compass and thermometer terminal 8.
- Replace compass and thermometer.
|
| Displays wrong temperature when ambient temperature is between -40°C (-40°F) and 55°C (130°F) (See NOTE above) |
- Check operation
- Ambient sensor circuit
- Vehicle speed signal is not entered
- Ambient sensor 2
- Compass and thermometer
|
- Perform preliminary check shown above.
- Check harness for open or short between ambient sensor 2 and compass and thermometer.
- Check harness for open or short between combination meter terminal 29 and compass and thermometer terminal 8.
- Replace ambient sensor 2.
- Replace compass and thermometer.
|
| Displays SC or OC |
- Ambient sensor circuit
- Ambient sensor 2
- Compass and thermometer
|
- Check harness for open or short between ambient sensor 2 and compass and thermometer.
- Replace ambient sensor 2.
- Replace compass and thermometer.
|