LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 1992 >> Sentra SE-R >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Other Variant >> Engine Control Systems >> Consult General Information (NTB93-134)

Consult General Information (NTB93-134)

WARNING: This page is about the Sentra E, 2D Sedan, Automatic, which is a different variant/trim than selected.
Publication date: 1993-09-22
Reference number: NTB93-134

CONSULT GENERAL INFORMATION

CONSULT GENERAL INFORMATION

TECHNICAL SERVICE BULLETIN

Reference Number(s): NTB93-134, Date of Issue:  September 22, 1993

CONSULT GENERAL INFORMATION

Model(s): All Nissan Models

Classification: GI93-010

Section: General Information

Bulletin No.: NTB93-134

Date: September 22, 1993

SERVICE INFORMATION

This bulletin gives updated general information for CONSULT. When performing a diagnosis using CONSULT, refer to the CONSULT Operations Manual for each system and the appropriate Service Manual for each model.

TOTAL SYSTEM

DESCRIPTION

Fig 1: CONSULT System Component Locations
G95F51768

The CONSULT unit is used to:

  • Display information that is stored in the electronic control unit (ECU) for each system on the vehicle. (Self-diagnostic result and ECU part number). * 
  • Measure directly and display signals from sensors and actuators. (Data monitor). * 
  • Drive actuators by communicating with the electronic control unit through the diagnostic connector for the CONSULT. (Active test and Work support). * 
  • Refer to the appropriate CONSULT operation manual for each CONSULT function.

Diagnostic Connector For The Consult

The diagnostic connector on the vehicle is connected to the electronic control units for each system in parallel.

Fig 2: Connecting CONSULT Unit to Vehicle
G95G51769

CONSULT can be used if:

  1. The vehicle has a diagnostic connector for CONSULT; and
  2. The vehicle system is CONSULT compatible (see CONSULT APPLICABLE SYSTEMS TABLE); and
  3. The CONSULT program card used to program the CONSULT unit has the applicable vehicle system information in it.

VEHICLE SYSTEMS

Fig 3: CONSULT APPLICABLE SYSTEMS
GB0017119

CONSULT MATERIALS

Fig 4: CONSULT Hardware Set
G95J51770
Fig 5: CONSULT Software Set
G95A51771

The following materials are contained in the CONSULT hardware set.

CONSULT HARDWARE SET ACCESSORY PARTS (SERVICE PARTS)

Part Name Part No.
CONSULT hardware set EG1180
Hard case EG1180-0010
Carrying case EG1180-0020
Roll paper (5 rolls/set) EG1180-0100
Ni-cd battery pack EG1180-0200
Lithium battery EG1180-0300
Cable pin probe EG1180-0501
Diagnostic data link cable EG1180-0510
Voltage measurement cable (without probe) EG1180-0520
Voltage cable test probe (red) EG1180-0521
Voltage cable test probe (gray) EG1180-0522
Voltage cable alligator clip (red) EG1180-0525
Voltage cable alligator clip (black) EG1180-0528
Pulse measurement cable (without probe) EG1180-0530
Pulse cable test probe (white) EG1180-0531
Pulse cable alligator clip EG1180-0535
Pulse measurement ground cable (without cable) EG1180-0540
Pulse ground cable test probe (black) EG1180-0541
Pulse ground cable alligator clip (black) EG1180-0545
Fig 6: SOFTWARE SET (PROGRAM CARD AND OPERATION MANUALS)
GB0017120

CONTENTS FOR EACH SOFTWARE SET - ENGLISH VERSION

Fig 7: SOFTWARE SET CONTENTS - ALL SETS TYPE
GB0017121
Fig 8: SOFTWARE SET CONTENTS - SUPPLEMENTAL TYPE
GB0017122

HOW TO ORDER CONSULT MATERIALS

To order CONSULT materials, write, call or Fax:

Kent-Moore SPX Corporation

29784 Little Mack

Roseville, MI 48066-2298

Telephone: 1-800-345-2233

Fax: (313) 578-7375