Changing Consult Battery (NTB91-046)
WARNING: This page is about the Sentra E, 2D Sedan, Automatic, which is a different variant/trim than selected.
Publication date: 1991-05-09Reference number: NTB91-046
CHANGING CONSULT BATTERY
TECHNICAL SERVICE BULLETIN
Reference Number(s): NTB91-046, Date of Issue:
May 9, 1991
CONSULT LITHIUM BATTERY REPLACEMENT
Model(s): All 1990-92 Nissan Models
Section: General Information
Classification: GI91-004
Bulletin No.: NTB91-046
Date: May 9, 1991
SERVICE INFORMATION
Your Nissan CONSULT Diagnostic unit incorporates two batteries:
- One is a NiCad rechargeable battery which powers the display and the printer.
- The other is a lithium battery to backup the memory, clock, and calendar functions when the NiCad battery has been removed or is completely discharged.
The lithium battery must be replaced once it is discharged. IT IS VERY IMPORTANT THAT THIS BATTERY BE REPLACED ONLY WITH A SANYO ELECTRIC CO. LTD., CR2032 BATTERY. Replacement batteries may be purchased locally. The replacement procedure is as follows:
CAUTION:
Use of another battery may create the risk of fire or explosion.
REPLACING THE LITHIUM BATTERY
- Press the power OFF switch.
- Remove the two card reader screws with a phillips screwdriver. Then remove the card reader as shown in Fig 1 . It is not necessary to disconnect the connector between the card reader and body.
- Remove the screw on the lithium battery compartment cover with a phillips screwdriver. Then remove the cover by pushing it in the direction of the arrow. See Fig 2 .
- Remove the lithium battery. See Fig 3 .
- Insert the new lithium battery with the plus and minus terminals correctly positioned. Then press the lithium battery down and replace the battery compartment cover. See Fig 4 .
- Press the power OFF switch and re-install the program card reader.