Special Tools
| TOOL | TOOL NUMBER AND NAME | SUPERSESSION | APPLICATION |
|---|---|---|---|
| MD998773 Knock sensor wrench |
MD998773-01 | Installation and removal of back-up light switch | |
| MD998245 Installer lock pin |
- | Installation of straight pin and spring pin | |
| MD998801 Bearing remover |
- | Installation and removal of bearing, gear and synchronizer clutch hub | |
| MD998812 Installer cap | General service tool or MIT304180-A |
|
|
| MD998814 Installer-200 | MIT304180-A |
|
|
| MD998816 Installer adapter (30) | - | Installation of bearing (Use with installer cap and installer) |
|
| MD998820 Installer adapter (42) | MD998820-01 | Installation of synchronizer clutch hub (Use with installer cap and installer) | |
| MD998817 Installer adapter (34) | Installation of synchronizer clutch hub number 3 (Use with installer cap and installer) |
||
| MD998813 Installer-100 | General service tool or MIT304180-A | Installation of bearing (Use with installer cap and installer adapter) | |
| MD998818 Installer adapter (38) | General service tool |
|
|
| MB992000 Crankshaft adapter | - | Installation of breather plug | |
| MB990211 MB990211 Slide hammer |
MB990211-01 | Removal of tapered roller bearing (outer race) | |
| MB992039 Slide hammer puller | MB992039-01 | ||
| MB990938 Handle | MB990938-01 | Removal and installation of tapered roller bearing (outer race) (Use with installer adapter) |
|
| MB990933 Installer adapter | - | Installation of tapered roller bearing (outer race) (Use with handle) | |
| MB990929 Installer adapter | - | Installation of tapered roller bearing (outer race) (Use with handle) | |
| MB992873 Installer oil seal | - | Installation of differential oil seal | |
| MB992075 Handle | - | ||
| MD999552 Remover, valve body & pump housing | - | Remove of tapered roller bearing (outer race) | |
| MB990801 Rear axle bearing outer race puller | - | ||
| MB990932 Installer adapter | - | Removal of tapered roller bearing (outer race) (Use with installer adapter) |
|
| MB991144 Side gear holding tool | - |
|
|
MB990641 Lower arm bush (A) remover and installer
|
- | Installation of tapered roller bearing (outer race) | |
| MB990931 Installer adapter |
- | Installation of tapered roller bearing (outer race) (Use with handle) | |
| MD998917 Bearing remover | General service tool or MD998348-01 | Remove of tapered roller bearing | |
| MD998821 Installer adapter (44) | - | Installation of tapered roller bearing (Use with installer cap and installer) |