Removal And Installation: Notes
- Before removing the driver's air bag module and steering wheel assembly, always refer to SERVICE PRECAUTIONSDRIVER'S AIR BAG MODULE AND CLOCK SPRING Also, set the front wheels so that they are facing straight forward, and remove the ignition key. If you fail to do this, the SRS clock spring will be damaged, causing the SRS (air bag) to be inoperative and serious injury.
- The parts indicated by * are the bolts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.
- After the installation, perform a calibration for the ASC-ECU to learn the steering wheel sensor neutral point. (Refer to STEERING WHEEL SENSOR CALIBRATION .
- After the installation, perform a calibration for the EPS-ECU to learn the torque sensor neutral point (Refer to TORQUE SENSOR CALIBRATION .
Pre-removal Operation
- Steering Wheel Assembly Removal (Refer to STEERING WHEEL .
- Engine Roll Stopper Rod Assembly Removal (Refer to ENGINE ROLL STOPPER ROD ).
- Lower Arm Assembly Removal (Refer to LOWER ARM .
- Front Floor Backbone Brace Removal (Refer to LOOSE PANEL .
Post-installation Operation
- Front Floor Backbone Brace Installation (Refer to LOOSE PANEL .
- Lower Arm Assembly Installation (Refer to LOWER ARM .
- Engine Roll Rod Assembly Installation (Refer to ENGINE ROLL STOPPER ROD ).
- Steering Wheel Assembly Installation (Refer to STEERING WHEEL .
- Checking Steering Wheel Position with Wheels Straight Ahead.
- Wheel Alignment Check and Adjustment (Refer to FRONT WHEEL ALIGNMENT CHECK AND ADJUSTMENT .
Removal steps
- Steering column bolt (Steering column shaft assembly and steering gear & linkage connection) (Refer to STEERING SHAFT .
- Self-locking nut (Tie-rod end and knuckle connection) (Refer to HUB AND KNUCKLE ASSEMBLY .
- Stabilizer link and stabilizer bar connection nut (Refer to STABILIZER BAR .
Removal steps
- Front end side panel mounting bolt (Refer to LOOSE PANEL .
- Front suspension crossmember assembly
- Grommet
- Stabilizer bar bracket
- Stabilizer bushing
- Stabilizer bar (Refer to STABILIZER BAR .
- Steering gear and linkage assembly
- Dynamic damper
<Up to 20 Model year>
- Front suspension crossmember