Electric Power Steering (EPS)
- Service Precautions
- Service Specifications
- Lubricant
- Sealant
- Special Tools
- Power Steering Diagnosis
- Diagnosis Troubleshooting Flow
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC C1219 Steering angle sensor signal
- DTC C1510 Torque sensor 1 signal malfunction; DTC C1511 Torque sensor 2 signal malfunction
- DTC C1512 Torque sensor 1, 2 excessive deviation
- DTC C1513 Torque sensor power supply too high; DTC C1514 Torque sensor power supply too low
- DTC C1517 Failure action of torque sensor signal
- DTC C1518 Torque sensor calibration not completed
- DTC C1519 Torque sensor calibration abnormality
- DTC C1521 Motor rotation angle sensor failure 1; DTC C1522 Motor rotation angle sensor failure 2
- DTC C1531 Motor output current failure 1; DTC C1532 Motor output current failure 2
- DTC C1537 IG signal failure
- DTC C1538 Detection of the steering neutral position deviation
- DTC C1540 Power supply voltage too high
- DTC C1541 Power supply voltage too low
- DTC C1543 IG voltage too high
- DTC C1550 ECU internal error
- DTC C1558 Invalid Data Received of Wheel speed information
- DTC C1559 Lost Communication of Wheel speed information
- DTC C1564 Vehicle speed data invalid
- DTC C1565 Engine revolution data invalid
- DTC C1567 Invalid data received for vehicle speed (CRC); DTC C1568 Invalid data received for vehicle speed (message counter)
- DTC C1657 Implausible coding data
- DTC U0100 Engine CAN timeout
- DTC U0121 ABS/ASC CAN timeout
- DTC U0126 SAS CAN timeout
- DTC U0141 ETACS CAN timeout
- DTC U1073 Bus-off
- DTC U1190 No receive fault detect signal
- DTC U1195 Coding not completed
- DTC U1199 VIN not programmed
- DTC U119A VIN mismatch
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Scan tool (M.U.T.-IIISE) cannot communicate with electric power steering system
- Inspection Procedure 2: When the heated steering wheel switch is turned on, the heated steering wheel is not activated.
- Inspection Procedure 3: The illumination light in the heated steering wheel switch does not come on.
- Inspection Procedure 4: The indicator for the heated steering wheel switch does not come on.
- Inspection Procedure 1: Scan tool (M.U.T.-IIISE) cannot communicate with electric power steering system
- Data List Reference Table
- Actuator Test Reference Table
- Special Function Table
- Check At Electric Power Steering-Ecu
- On-Vehicle Service
- Steering Wheel
- HEATED STEERING WHEEL SWITCH
- Steering Column Shaft Assembly
- Intermediate Shaft Assembly
- Power Steering Gear Box And Linkage
- Electric Power Steering Control Unit (EPS-Ecu)