LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Mirage ES, Standard Trans >> Repair and Diagnosis >> Maintenance >> Procedures >> General - Body & Chassis >> Maintenance Service >> Engine Oil

Engine Oil

  1. Start the engine and allow it to warm up until the temperature of the engine coolant reaches 80 - 90°C (176 - 194°F).
    WARNING: Use care as engine oil could be hot.
  2. Remove the oil filler cap.
  3. Remove the oil drain plug to drain engine oil.
  4. Install a new oil drain plug gasket and then tighten the oil drain plug to the specified torque.

    Tightening torque: 39 ± 5 N.m (29 ± 3 ft-lb) 

    Fig 1: Locating Engine Oil Drain Plug
    G09628114Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Refill with specified quantity of engine oil.

    Specified Engine Oil: Engine oils displaying the ILSAC certification symbol ("Starburst" symbol) or conforming to the API classification SN 

    Total quantity (Includes volume inside engine oil filter): 3.0 dm 3  (3.21 quarts) 

    NOTE: SAE 0W-20 engine oil is strongly recommended for optimum fuel economy and cold starting.
    If SAE 0W-20 is not available, the ILSAC certification oil of other viscosity grades can be temporarily used.
    Fig 2: Identifying Engine Oil Viscosity Grade
    G09628115Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Install the oil filler cap.
  7. Let the engine run for a few minutes.
  8. Stop the engine, and then check the engine oil level using the engine oil dipstick after a few minutes.