LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Automatic CVT >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transaxle On-Vehicle Service - Lancer SPORTBACK >> Transaxle Assembly >> Removal And Installation >> Installation Service Points >> >>C<< Transaxle Control Cable (Transaxle Side) Installation

>>C<< Transaxle Control Cable (Transaxle Side) Installation

  1. Move the selector lever to the "N" range.
  2. Move the manual control lever to Neutral position.
  3. Align the hole at the end of the manual control lever and the hole in the inhibitor switch body flange (section A - A).
    NOTE: Insert ø5 mm (0.2 inch) bar into the aligned holes in the transmission range switch body flange and on the tip of the manual control lever to position the transmission range switch body.
    Fig 1: Identifying Manual Control Lever
    G06481867Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Use the adjusting nut to tighten the transmission control cable to the specified torque.

    Tightening torque: 9.5 ± 3.5 N.m (84 ± 31 in-lb) 

  5. Make sure that the transmission-side ranges that are corresponding to the transmission range operate and function without fail.
Fig 2: Identifying Transaxle Control Cable And Adjusting Nut
G05375810Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.