LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 49 (Multi-Media Communications System (MMCS) - Lancer SPORTBACK) >> Diagnosis >> Service Mode >> Sensor Check

Sensor Check

WARNING: This page is about a different variant/trim than selected.

The speed sensor and gyro sensor will be checked, depending on the vehicle conditions such as driving condition, stationary condition and travel direction change.

  1. Select "Sensor Check" on "Service" screen.
    Fig 1: Screen Display - Vehicle Signal Check
    G05385459Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. The sensor check with the vehicle stationary will be executed in accordance with the screen.
    Fig 2: Screen Display - Sensor Check
    G05385481Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 3: Screen Display - Sensor Check
    G05385482Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. The sensor check with the vehicle in motion will be executed in accordance with the screen.
    Fig 4: Screen Display - Sensor Check
    G05385483Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. When the sensor checks are complete, the screen will display the check results.
    NOTE: If there is "NG" or "N/A" as the check results, select "NG Code" on the "Sensor Check" screen. Then "NG code Indication" screen will show the NG code.
    Fig 5: Screen Display - Speed Sensor
    G05385484Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 6: Screen Display - NO Code Indication
    G05385485Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

    NG CODE REFERENCE TABLE FOR SENSOR CHECK 

    SENSOR CLASSIFICATION CHART

    Sensor classification NG code No. Error items
    Gyro sensor 1 Offset error while the vehicle is stationary (lower limit error)
    2 Offset error while the vehicle is stationary (upper limit error)
    5 Output error during driving
    Speed sensor 6 Output error while the vehicle is stationary