LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Charging System - Lancer SPORTBACK) >> Generator Assembly >> Inspection >> Rectifier Assembly <2.4L Engine>

Rectifier Assembly <2.4L Engine>

WARNING: This page is about a different variant/trim than selected.
  1. Check the condition of the (+) heat sink by checking the continuity between the (+) heat sink and each of the stator coil lead connecting terminals.

    If the continuity is present for both terminals, or if no continuity is present for both terminals, the diode is shorted. Replace the rectifier assembly.

    Fig 1: Checking Continuity Between (+) Heat Sink And Each Of Stator Coil Lead Connecting Terminals
    G05375423Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check the condition of the (-) heat sink by checking the continuity between the (-) heat sink and each of the stator coil lead connecting terminals.

    If the continuity is present for both terminals, or if no continuity is present for both terminals, the diode is shorted. Replace the rectifier assembly.

    Fig 2: Checking Continuity Between (-) Heat Sink And Each Of Stator Coil Lead Connecting Terminals
    G05375424Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.