LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Combination Meter - Lancer SPORTBACK) >> On-Vehicle Service >> Fuel Level Sensor Check >> Nominal Resistance Of The Fuel Level Sensor

Nominal Resistance Of The Fuel Level Sensor

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel pump module (Refer to FUEL TANK <2.4L ENGINE> or FUEL TANK <2.0L ENGINE> ).
  2. When float of the fuel level sensor is in stopper positions F and E, ensure that resistance between the fuel level sensor terminal and ground terminal is within the standard value.

    <FWD> Standard value: 

    FUEL LEVEL SENSOR SPECIFICATION (FWD)

    Float position Gauge resistance value (Ω)
    Stopper position "F" 13.0 ± 1.0
    Stopper position "E" 120.0 ± 1.0

    <AWD> Standard value: 

    FUEL LEVEL SENSOR SPECIFICATION (AWD)

    Float position Gauge resistance value (Ω)
    Main Sub
    Stopper position "F" 6.5 ± 1.0 6.5 ± 1.0
    Stopper position "E" 41.9 ± 1.0 78.1 ± 1.0
    Fig 1: Checking Fuel Level Sensor For Resistance
    G05906327Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. When the float is moved slowly between stopper positions "F" and "E", ensure that the resistance is smoothly changing.