LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Basic Brake System - Lancer SPORTBACK) >> On-Vehicle Service >> Brake Pad Check

Brake Pad Check

WARNING: This page is about a different variant/trim than selected.
CAUTION: If there is a significant difference in thickness between the brake pads at right and left, check the sliding area and the runout of the brake disk (Refer to DISK BRAKE ROTOR CHECK ).
  1. Visually check the thickness of brake pad from the inspection hole of the caliper body.

    Standard value: 10.0 mm (0.39 inch) 

    Limit: 2.0 mm (0.08 inch) 

  2. If the brake pad thickness is less than the limit value, replace the brake pad (Refer to BRAKE PAD REPLACEMENT <2.0 L ENGINE>  or BRAKE PAD REPLACEMENT <2.4 L ENGINE> ).
Fig 1: Locating Brake Pad Thickness - Front 2.0L Engine
G06472287Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 2: Locating Brake Pad Thickness - Front 2.4 L Engine
G06472288Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 3: Locating Brake Pad Thickness - Rear
G05901864Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.