Brake Drag Force Check
WARNING: This page is about a different variant/trim than selected.
- Remove the brake pad, shim and clip (Refer to BRAKE PAD REPLACEMENT <2.0 L ENGINE> or BRAKE PAD REPLACEMENT <2.4 L ENGINE> ).
- Using a spring scale, measure the hub sliding torque in the forward direction with the brake pad, shim and clip removed.
- Install the brake pad, shim and clip (Refer to BRAKE PAD REPLACEMENT <2.0 L ENGINE> or BRAKE PAD REPLACEMENT <2.4 L ENGINE> ).
- Start the engine, and depress the brake pedal forcibly two or three times. Then, stop the engine.
- Turn the brake disk 10 times in the forward direction.
- Using a spring scale, measure the hub sliding torque in the forward direction with the brake pad, shim and clip installed.
- Obtain the disk brake drag force (difference between measured values of item 2 and item 6).
Standard value:
85 N (19.1 lb) or less <Front (2.0 L Engine)>
68 N (15.3 lb) or less <Front (2.4 L Engine)>
68 N (15.3 lb) or less <Rear>
- If the brake drag force exceeds the standard value, disassemble the brake caliper assembly to check for fouling/rust on the piston sliding section and piston seal deterioration, and confirm whether the guide pin and lock pin slide properly (Refer to DISASSEMBLY AND ASSEMBLY <2.0 L ENGINE> <Front (2.0 L Engine)>, DISASSEMBLY AND ASSEMBLY <2.4 L ENGINE> <Front (2.4 L Engine)>, DISASSEMBLY AND ASSEMBLY <2.0 L ENGINE> <Rear (2.0 L Engine)> or DISASSEMBLY AND ASSEMBLY <2.4 L ENGINE> <Rear (2.4 L Engine)>).