LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Automatic CVT >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control -- Lancer >> On-Vehicle Service >> Cruise Control System Component Check >> Cruise Control Switch Check

Cruise Control Switch Check

  1. Remove the cruise control switch (Refer to REMOVAL AND INSTALLATION <2.0L ENGINE NON-TURBO, 2.4L ENGINE>  ) <2.0L ENGINE Non-turbo, 2.4L ENGINE> or (Refer to REMOVAL AND INSTALLATION <2.0L ENGINE TURBO>  ) <2.0L ENGINE Turbo.>
  2. Measure the resistance between terminal number 2 and terminal number 3 when each of the "ON/OFF", "CANCEL", "COAST/SET" and "ACC/RES" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.
    CONNECTOR TERMINAL REFERENCE

    Terminal connector of tester Switch position Specified condition
    2 - 3 All switches are released. Open circuit
    "ON/OFF" switch is pressed Continuity (less than 2 ohms)
    "CANCEL" switch is pressed 202.5 - 208 Ω
    "COAST/SET" switch is pressed 610.5 - 624.5 Ω
    "ACC/RES" switch is pressed 1838 - 1877 Ω
    Fig 1: Locating Cruise Control Switch (2.0L ENGINE Non-turbo, 2.4L ENGINE)
    G06668583Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Check that the cruise control switch illuminates when a positive battery terminal is connected to the connector terminal number 4, and terminal number 1 is grounded.
    Fig 2: Locating Cruise Control Switch (2.0L Engine Turbo)
    G06668584Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.