LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling >> Sensor - Engine Coolant Temperature >> Removal- 3.7L Engine

Removal- 3.7L Engine

Fig 1: Locating Engine Coolant Temperature Sensor (3.7L)
G04283954Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

The Engine Coolant Temperature (ECT) sensor (3) on the 3.7L engine is installed into a water jacket at front of intake manifold near rear of generator.

WARNING: HOT, PRESSURIZED COOLANT CAN CAUSE INJURY BY SCALDING. COOLING SYSTEM MUST BE PARTIALLY DRAINED BEFORE REMOVING THE COOLANT TEMPERATURE SENSOR.
  1. Partially drain the cooling system. (Refer to STANDARD PROCEDURE ).
  2. Disconnect the electrical connector from the sensor (3).
  3. Remove the sensor from the intake manifold.