LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Steering >> Steering Column >> Power Steering >> Switch - Ignition >> Installation

Switch - Ignition: Installation

The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before installing ignition switch.

  1. Before installing ignition switch, rotate the slot in the switch to the ON position.
    Fig 1: Connecting Electrical Connector To Rear Of Ignition Switch
    G04286331Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Connect the electrical connector to rear of the ignition switch. Make sure that locking tabs are fully seated into wiring connector.
  3. Position switch (1) to column and install the mounting screws (2). Tighten screw to 3 N.m (26 in. lbs.).
    Fig 2: Installing Tilt Lever Bracket Mounting Screws
    G04286332Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Install the tilt lever bracket (2) mounting screws. Tighten screws to 4.5 N.m (40 in. lbs.).
    Fig 3: Installing Bracket
    G04286333Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. If the column is non-tilt install the bracket. Tighten screws (2) to 4.5 N.m (40 in. lbs.)
    Fig 4: Installing Key Cylinder
    G04286334Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  6. Position the wire retainer into the tilt lever bracket.
  7. Reconnect the lower clockspring connectors.
  8. Install the key cylinder (1)
  9. Install steering column upper and lower shrouds.
  10. Enable the airbag system. (Refer to INSTALLATION ).