LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2006 >> Raider XLS, RWD >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraint System (SRS) >> Service Information >> Description >> Passive Restraints

Passive Restraints

Fig 1: Identifying Passive Restraints Sticker
G04287616Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

The passive restraints available for this model include the following:

Fig 2: Identifying Passive Airbag Switch
G04287617Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 3: Identifying SRS - Airbag Logo Location
G04287618Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

The supplemental restraint system includes the following major components, which are described in further detail elsewhere in this service information:

The ORC, the OCM, and the EMIC each contain a microprocessor and programming that allow them to communicate with each other using the Controller Area Network (CAN) data bus. This method of communication is used by the ORC for control of the airbag indicator in the EMIC. (Refer to DESCRIPTION ).

Hard wired circuitry connects the supplemental restraint system components to each other through the electrical system of the vehicle. These hard wired circuits are integral to several wire harnesses, which are routed throughout the vehicle and retained by many different methods. These circuits may be connected to each other, to the vehicle electrical system, and to the supplemental restraint system components through the use of a combination of soldered splices, splice block connectors, and many different types of wire harness terminal connectors and insulators. Refer to SYSTEM WIRING DIAGRAMS . The wiring information includes wiring diagrams, proper wire and connector repair procedures, further details on wire harness routing and retention, as well as pin-out and location views for the various wire harness connectors, splices and grounds.