Active Restraints
The active restraints for this model include:
- Front Seat Belts - Both outboard front seating positions are equipped with three-point seat belt systems employing floor sill mounted (extended cab) or lower B-pillar mounted (double cab) inertia latch-type emergency locking retractors, height-adjustable roof rail mounted (extended cab) or upper B-pillar mounted (double cab) turning loops, a traveling lower seat belt anchor secured to the outboard side of the seat frame, and a traveling end-release seat belt buckle secured to the inboard side of the seat frame. The driver side front seat belt buckle includes an integral seat belt switch that detects whether the driver side front seat belt has been fastened. A fixed position lap belt and buckle is provided for vehicles with a center front seating position.
- Rear Seat Belts - On all vehicles equipped with rear seats, each rear seating position is equipped with a three-point seat belt system. The outboard seating position belts employ lower rear pillar mounted inertia latch-type emergency locking retractors, fixed position upper rear pillar mounted turning loops, self-cinching latch plates for compatibility with child seats and fixed lower seat belt anchors secured to the floor panel (extended cab) or lower rear pillar (double cab). The double cab rear seat center seating position belt has an inertia latch-type emergency locking retractor secured to the rear floor panel and a routing bracket secured to the top of the cab back panel. Fixed end-release buckles are secured to the floor panel on extended cab models. On double cab models the buckle units for the center and left outboard seating positions are secured to the floor panel with the rear seat mounting hardware, while the center anchor buckle and the right outboard buckle are secured to the floor panel with the center retractor mounting hardware.
- Child Restraint Anchors - All vehicles with rear seats are equipped with three child seat upper tether anchors that are secured to the upper cab back panel reinforcement. On extended cab models the two outboard anchors are loops of webbing located behind the hinged upper rear seat back pads, while the center anchor is a stamped "D" ring located behind a small hinged access door in the center of the cab back trim panel. On double cab models all three anchors include a "D" ring covered by a loop of webbing strap located behind the rear seat backs. Extended cab models also have an upper tether anchor integral to the back of the passenger side front seat cushion frame. Two lower anchors are also provided for the passenger side outboard front and rear seating positions of extended cab models, and for each rear outboard seating position on double cab models. These lower anchors are accessed from the front of the seat where the seat back meets the seat cushion. The child seat tether and lower anchors for the front seat are deleted on double cab models.